STLP 9128 F - Stacked Log Periodic Antenna

NEW

 

  • STLP 9128 F - Max. Input Power
  • STLP 9128 F - Typical Antenna Factor
  • STLP 9128 F - Typical Antenna Gain
 

The stacked Log Periodic Dipole Antenna (Stacked LPDA) consists of two ordinary Log.-Per. structures. The excellent characteristics (flat gain over a large bandwidth, low SWR) of the ordinary LPDA designs could be maintained using the stacked LPDA design. The stacked design helps to focus the directional pattern of the H-plane somewhat, resulting in a typical gain improvement of 2.0 dB compared to an ordinary LP antenna. This is especially important for immunity testing, where a maximum fieldstrength and a good field uniformity is required. The beamwidth in the E-plane and the H-plane are nearly identical, providing an optimised illumination of the EuT with minimised ground reflection influence.Further the cross polar rejection of the STLP 9128 F is excellent. The fastlinks allows to disassemble the rear elements without any need for further tools within a few seconds. These fastlinks divide the antenna into five parts, which can be stored and transported easily.

 

Main Application: Generation of defined high field strength levels for radiated immunity testing.

 

Frequency Range:

(55)70-1500(3000) MHz

Polarisation:

linear

Pattern Type:

directional

Material:

Aluminium

Max Power (7/16): 

2 kW (const.)
3 kW (intermitt.)

Max Power (N): 

1 kW (const.)
1.5 kW (intermitt.)

Connector: 

Type 7/16 female
Type N female

Impedance: 50 Ohms nominal

 

Length: 1950 mm
Width: 2260 mm
Height 2540 mm
Weight: 11.0 kg
Mounting: 22 mm diameter tube

 

 

 

[fastlinks.pdf] for quick removal of the rear parts of the antenna.

 

Recommended Adapter: AA 9209.

 

 

Datasheet STLP 9128 F

Assembly of STLP Antennas